The universal Door/Window Contact + Terminals is totally wireless and can be mounted anywhere to secure door and window openings. It comes with both NO and NC terminals and can be used in conjunction with other third party sensors.
Description
The Door Contact Models CT is a battery operated, wireless door contact designed for use in Videofied security systems. Door contacts are intended for use in detecting the opening and closing of doors, windows, or cabinet doors/drawers. The CT consist of a switch detector with S2View spread spectrum, Videofied, interactive, encrypted wireless circuitry for secure two-way communications with the control panel. A dual tamper function provides detection for both wall and cover tamper. The transmitter is typically installed on the stationary surface of an opening (door frame or window frame), while the magnet is installed on the door or window. With the door or window closed, the magnetic field forces a reed switch inside the detector to close, creating a secured condition. When the alarm system is armed and the door or window is opened, the detector transmits an open signal. The control panel receives this signal and responds according to system configuration/programming. The external input terminals accepts a normally closed remote switch. You can also connect a dry closed circuit (no power) from standard hardwire intrusion or smoke/heat detectors. An internal jumper selects the sensors mode of operation, whether the internal reed switch, external input, or both are active. The detector is powered by one lithium battery that can last up to four years, depending on the amount of detector activity. The detector transmits a check-in signal every eight minutes that includes its unique identification code along with the current alarm state, tamper conditions, serial number, date of manufacture, software version and battery status.
Features
– S2View – Spread Spectrum, Videofied, Interactive, AES Encrypted Wireless technology provides optimum signal integrity and security.
– Supervised – transmits a check-in/status signal every 8 minutes indicating open/closed state, tamper conditions, serial number, date of manufacture, software revision and battery status.
– Dual tamper – provides detection for both wall and cover tamper.
– External input – accepts normally closed (NC) dry (no power) circuits from standard hardwire intrusion devices, including fast response devices.
– Three working modes: internal reed switch only, external input only, internal switch and external input.
– Lithium battery – up to four years.
Applications
Residential
– Doors
– Windows
– Cabinet doors/drawers
– Other similar openings
Commercial
– Doors
– Windows
– Overhead garage doors
– Cabinet doors/drawers
– Other similar openings
Technical Specifications
Electrical Data
Panel Compatibility XL, XLL, Visio, XT, XT-iP, XV, XV-iP, XTO
Power requirements
Nominal Voltage 3.6V
Low battery limit 2.7V
QTY and Battery Type One 3.6V Lithium battery
Battery type SAFT Lithium, 1x LS14500 (NOT INCLUDED)
Battery life Up to 4 years
Current Consumption
Max 70mA
Axis of detection Three axis (X, Y, Z)
Opening Detection Distance 2.3cm
Closing Detection Distance 2.0cm
RF technology S2View
Radio type Spread Spectrum Bidirectional RF
Operating frequency 868 MHz
Transmission security AES algorithm encryption
Supervision Polled signal every 8 minutes
Antenna Integrated
Tamper detection Wall and cover tampered
External terminal input type Normally closed (NC)
Working modes 1-internal reed switch only
2-external input only
3-internal switch and external input
Mode selection Jumper wire on 3-position terminal block
Maximum external wire length 16 m
Operating temperature -10 – +40 C
Maximum relative humidity 75%, non-condensing
Physical Data
Material Plastic: ABS – ULV0
Magnet Alnico 5
Dimensions (LxWxD) 80 mm x 35 mm x 23 mm
Weight: Detector 40 g – without battery
Installation/Mounting
Detector
One screw secures detector to base; two screws secure detector to mounting surface.
Magnet
Two screws secure magnet assembly to mounting surface.
Spacing
Maximum 10mm gap between detector and magnet.